Specifications

User Manual 301/302
Figure 3.24 Selecting the active sequence and entering sequences
Running
Sequences
Using WaveWiz
If “output waveform” is set to “Arbitrary” on the output tab of the
Instrument control panel, selecting different segments in the segment
control window will result in that segment being output from the
301/302 (if the output is turned on). To run a sequence, select
“sequenced” on the output tab. The sequence defined in the sequence
table will now be output.
Figure 3. 25 Selecting Sequence output mode
Sequences may be advanced in a number of different ways
dependent on application. These are also selected on the sequence
tab. For a discussion on the various advance modes, see section
Sequence Advance Commands.
Configuring The Instrument
64