Specifications

7
, ,,
I
WAVETEK
MO~EI.. 132
VCG!NQISE GENERATOR
Figure 2-l. Operating Controls, Front Panel
10.
11.
12.
FM - Depressing this push button along with
the FUNC push button (7) allows the selected
signal, either
/‘\
A
u , v , or
z
wave, to be
pseudo-randomly frequency modulated, or jit-
tered. The modulating signal is provided by
pseudo-random analog noise, and the S/N
-
N/S (dB) controls frequency deviation. The
bandwidth of the modulating signal is controlled
by the NOISE
FREQ HZ selector (15) and
vernier (16).
5Oa OUT - Provides the selected generator out-
put function. The generator may operate into an
open circuit providing 20 V peak to peak maxi-
mum, or into a
5Oa load providing a 10 V peak
to peak output.
OUTPUT
ATTEN (dB) - Attenuates the output
(both signal and noise) from 0
dB to -60 dB in
six calibrated 10
dB steps according to the fol-
lowing table:
Step
Attenuator
Position
Output peak to peak into
5Ofl Load
Maximum Minimum
Vernier Vernier*
fully cw
0
dB 10V
IV
-10
dB
3V
0.3 v
-20
dB IV 0.1 v
-30
dB 0.3 v 0.03 v
-40
dB 0.1 v
0.01 v
-50
dB
0.03 v 0.003 v
-60
dB 0.01 v 0.001 v
* The values in this table are approximate. The OUT-
PUT VERNIER
(dB) (6) will reduce the output
approximately 20
dB in all cases, as shown.
13.
S/N
- N/S (dB) - I n the S/N mode, this control
attenuatesthe analog noise from
0 to -50 dB in
five calibrated 10
dB steps. The selectable signal
5