Installation Guide

Description:

• Connect the Spectra controller as shown in wiring diagram above.

• When using TCP Active Hub, Spectra can be configured to transfer data for displays (CDUs, SDUs

and PDUs) and HTSUs over LAN connection to TCP Active Hub.

• TCP Active Hub must be connected to same local network as Spectra is connected to.

• It is recommended to use this mode if using TCP Active Hub (for setting up TCP Active Hub refer

“TCP Active Hub installation guide”)

Note:

• It is recommended to use Cat5e or Cat6 LAN cable/Patch cord.

• When operating in LAN mode CDU and TSU ports on Spectra will not be used.