Data Sheet

NEO-7 - Data Sheet
UBX-13003830 - R04 Early Production Information Default messages
Page 23 of 26
8 Default messages
Interface Settings
UART Output 9600 Baud, 8 bits, no parity bit, 1 stop bit
Configured to transmit both NMEA and UBX protocols, but only following NMEA and no UBX messages
have been activated at start-up:
GGA, GLL, GSA, GSV, RMC, TTG, TXT
USB Output Configured to transmit both NMEA and UBX protocols, but only following NMEA and no UBX messages
have been activated at start-up:
GGA, GLL, GSA, GSV, RMC, TTG, TXT
USB Power Mode: Bus Powered
UART Input 9600 Baud, 8 bits, no parity bit, 1 stop bit, Autobauding disabled
Automatically accepts following protocols without need of explicit configuration:
UBX, NMEA
The GNSS receiver supports interleaved UBX and NMEA messages.
USB Input Automatically accepts following protocols without need of explicit configuration:
UBX, NMEA
The GNSS receiver supports interleaved UBX and NMEA messages.
USB Power Mode: Bus Powered
TIMEPULSE
(1Hz Nav)
1 pulse per second, synchronized at rising edge, pulse length 100ms
Table 12: Default messages
Refer to the u-blox 7 Receiver Description Including Protocol Specification [2] for information about further
settings.