User Guide

MPLAB
®
PICkit™ 4 User’s Guide
DS50002751C-page 46  2018 Microchip Technology Inc.
PRESERVE_MEM_RANGE_WONT_BE_PROGRAMMED_AUTO_SELECT=Some or all of the preserve memory
ranges (%s) entered on the, "Memories to Program" property page, do not fall under the indicated program range(s)
(%s) for the memory selected. Please deselect the \u201cAuto select memories and ranges\u201d option on the
\u201cMemories to Program\u201d property page, change to manual mode and adjust your range(s) accordingly
PRESERVE_MEM_RANGE_WONT_BE_PROGRAMMED=Some or all of the preserve memory ranges (%s)
entered on the, "Memories to Program" property page, do not fall under the indicated program range(s) (%s) for the
memory selected. Please check the preserved ranges on the debug tool's, "Memories to Program" property page.
PROGRAM_CFG_WARNING=WARNING: You have selected to program configuration memory. Programming
invalid values into any of the configuration fields may have unintended consequences. Please make sure that
EVERY configuration field has a valid value. If you are not sure, you can read the configuration values off of device
first and then change only the fields you are concerned with. Would you like to continue programming?
PROGRAM_COMPLETE=Programming/Verify complete
PROGRAM_MEMORY=program memory
PROGRAM=program
PROGRAMMING_DID_NOT_COMPLETE=Programming did not complete.
READ_COMPLETE=Read complete
READ_DID_NOT_COMPLETE=Read did not complete.
RELEASEMCLR_FAILED=Release from reset failed.
REMOVING_SWBPS_COMPLETE=Removing software breakpoints complete
REMOVING_SWBPS=Removing software breakpoints...
RESET_FAILED=Failed to reset the device
RESETTING=Resetting...
RISKY_CFG_RANGE_REMOVED=The configuration memory will not be included in the program operation because
the, "Exclude configuration memory from programming" option is set. To change this, go to the Memories to Program
property page and uncheck the setting.\nWARNING; Programming configuration values on this device can cause
unintended consequences if all of the configuration values are not properly set. It is advised that you read the config-
uration values off of device first and then change only the fields you are concerned with.
RUN_INTERRUPT_THREAD_SYNCH_ERROR=An internal run error has occurred. It is advised that you restart
your debug session. You may continue running but certain run time features may no longer work properly.
RUN_TARGET_FAILED=Unable to run the target device.
RUNNING=Running
SERIAL_NUM=Serial Number:\n
SETTING_SWBPS=Setting software breakpoints.......
STACK=stack
START_AND_END_ADDR=start address = 0x%x, end address = 0x%x
START=start
TARGET_DETECTED=Target voltage detected
TARGET_FOUND=Target device %s found.
TARGET_HALTED=Target Halted
TARGET_NOT_READY_4_DEBUG=The target device is not ready for debugging. Please check your configuration
bit settings and program the device before proceeding. The most common causes for this failure are oscillator and/or
PGC/PGD settings.
TARGET_VDD=Target VDD:
TEST=test
TOOL_INFO_MEMBERS=ToolInfo: speedLevel = %d, PGCResistance = %d, PGDResistance = %d, PGCPullDir =
%s, PGDPullDir = %s, ICSPSelected = %s
TOOL_INFO=ToolInfo: Values:
TOOL_IS_BUSY=PICKit 4 is busy. Please wait for the current operation to finish.
TOOL_SUPPLYING_POWER=PICKit 4 is supplying power to the target (%.2f volts).
TOOL_VDD=VDD:
TABLE 6-1: ALPHABETIZED LIST OF ERROR MESSAGES (CONTINUED)