Data Sheet
9/24/2015 ARPI600WaveshareWiki
http://www.waveshare.com/wiki/ARPI600 6/18
Building a wireless network with two XBee modules
Preparations
1. Two XBee modules
2. Two ARPI600 modules
3. Twp Raspberry Pi boards
In this document, we will divided the device above into two groups: Group A and
Group B, of which Group A contains XBee‐A, Raspberry Pi board‐A and ARPI600‐A, and
Group B contains XBee‐B Raspberry Pi board‐B and ARPI600‐B.
Installing X‐CTU tool
1. Double click the file software/X‐CTU V5.2.8.6.exe on your PC to start installing X‐CTU tool.
After a successful installation, you can open the X‐CTU tool as the figure shows.
X‐CTU setting
2. Configure the XBee module. The default setting of XBee is as followed:
Baud: 9600
Data Bite: 8
Parity: NONE
Stop: 1