Data Sheet
9/24/2015 ARPI600WaveshareWiki
http://www.waveshare.com/wiki/ARPI600 15/18
Configuring the jumpers D11, D12 and D13
In factory settings, the jumpers are set as followed:
Connect SCK to D13
Connect MISO to D12
Connect MOSI to D11
The following settings are connecting pins D11, D12 and D13 to the general IO control pins of
Raspberry Pi board.
Connect D13 to P26
Connect D12 to IO_SD
Connect D11 to IO_SC
Notices: Users can modify the settings of these jumpers as required. In this operation,
welding is required. Any changes under no guidance from Waveshare will be considered as
a waiver of warranty.
The pins A0‐A5 of ARPI600 can also be configured as IO pins or ADC pins.
configuring Pins A0‐A5
a﴿ When the pins A0‐A5 are connected to 1, they will sever as IO control pins. The
relationship between the pins A0‐A5 and the pins of Raspberry Pi board is as the table
shows.
The relationship between the pins A0‐A5 and the pins of Raspberry Pi board