Data Sheet
9/24/2015 ARPI600WaveshareWiki
http://www.waveshare.com/wiki/ARPI600 10/18
6. This Figure shows the normal operating state of XBee module.
How to perform wireless transmission with XBee
Before performing the wireless transmission with XBee, please make sure the wireless network
built by two XBee modules is work properly. For more information about how to build the wireless
network, please refer to Section 3.
1. Set the jumpers on ARPI600:
Here, we should use two Raspberry Pi boards: Raspberry Pi‐A and Raspberry Pi‐B, of
which Raspberry Pi‐A is used for transmitting data and Raspberry Pi‐B is used for
receiving data.
Connect Raspberry Pi‐A to the serial port of XBee‐A and Raspberry Pi‐B toXBee‐B,
respectively. And then, set the jumpers on ARPI600, as the shows.
Connect XB_RX to P_TX
Connect XB_TX to P_RX
Setting jumpers on ARPI600