Datasheet

0 1 HRED[7:3] 1 1 1
0 1 - - - - - - - VRST[8]
0 1 VRST[7:0]
0 1 - - - - - - - VRED[8]
0 1 VRED[7:0]
0 1 - - - - - - - PT_SCAN
This command sets partial window.
HRST[8:3]: Horizontal start channel bank. (value 00h~31h)
HRED[7:3]: Horizontal end channel bank. (value 00h~31h). HRED must be greater than HRST.
VRST[8:0]: Vertical start line. (value 000h~12Bh)
VRED[8:0]: Vertical end line. (value 000h~12Bh). VRED must be greater than VRST.
PT_SCAN: 0: Gates scan only inside of the partial window.
1: Gates scan both inside and outside of the partial window. (default)
(32) Partial In (PTIN) (R91H)
Action W/R C/D D7 D6 D5 D4 D3 D2 D1 D0
Partial In 0 0 1 0 0 1 0 0 0 1
This command makes the display enter partial mode.
(33) Partial Out (PTOUT) (R92H)
Action W/R C/D D7 D6 D5 D4 D3 D2 D1 D0
Partial In 0 0 1 0 0 1 0 0 1 0
This command makes the display exit partial mode and enter normal mode.
(34) Program Mode (PGM) (RA0H)
Action W/R C/D D7 D6 D5 D4 D3 D2 D1 D0
Enter Program
Mode
0 0
1 0 1 0 0 0 0 0
0 1 1 0 1 0 0 1 0 1
After this command is issued, the chip would enter the program mode.
The mode would return to standby by hardware reset.
The only one parameter is a check code, the command would be excuted if check code = 0xA5.
(35) Active Program (APG) (RA1H)
Action W/R C/D D7 D6 D5 D4 D3 D2 D1 D0
Active Program OTP 0 0 1 0 1 0 0 0 0 1
After this command is transmitted, the programming state machine would be activated.
The BUSY flag would fall to 0 until the programming is completed.
4.2" e-Paper
www.waveshare.com
24／45