User Guide

Waves V-Series
page 8
Trim meter and reset button
Measures the output peak of the EQ device, measured in dBFS.
Click on the trim button to reset the output of the EQ to -0.1 dBFS. A
red clip light indicates over-level. It can be reset by clicking on it.
Analogue on/off
The V-EQ3 achieves an accurate vintage sound by recreating the unique
harmonic distortion and noise characteristics (and therefore the sound color) of the 1073
and 1066 devices, after which it was modeled. Turning off both the Analogue and EQ
switches bypasses this analogue modeling completely. You can also bypass the device
by using your host application’s plug-in bypass.
Controls for the V-EQ4 EQ
As with the V-EQ3 EQ, you can select a frequency by clicking the desired location on a
knob. The inner knob sets the gain for a filter, while the outer ring is used to set the
frequency. Click on a desired frequency to select that value, then drag to a gain value,
which is continuously variable. If you prefer, you can enter values numerically by