User Guide

Waves V-Series
page 6
HP (High Pass Filter)
Seven cutoff points, plus off. -18 dB/octave
V-EQ3 HP cutoff points (Hz): 45, 50, 70, 80, 160, 300, 360
EQ (EQ on/off)
This control defeats the EQ, but does not turn off analogue modeling. EQ Off is
comparable to an analogue EQ device in an idle mode. Signal will still be subject to the
harmonic distortion and noise characteristics of the 1073 and 1066 devices after which
the plug-in was modeled. To completely bypass the V-EQ3, turn off EQ as well as
Analogue, or simply select the host application’s plug-in bypass button.
Phase (Phase Reverse)
Selecting this switch reverses the phase of the output signal.
LF (Low Frequency Section)
Controls low frequency gain and cutoff frequency.
Inner knob controls gain, up to ±18 dB, continuously adjustable.
Outer ring selects low frequency cutoff points, plus off. Five cutoff points.
V-EQ3 LF cutoff points (Hz): 35, 60, 100, 110, 220
Slope: ±18 dB per octave
MF (Mid Frequencies, or “Presence,” Section)
Controls middle frequency gain and cutoff frequency.
Inner knob controls gain, ±18 dB, continuously adjustable.
Outer ring selects mid frequency cutoff points, plus off.
V-EQ3 MF cutoff points (kHz): 0.36, 0.70, 1.2, 1.6, 3.2, 3.8, 4.8, 7.0, 7.2
HF (High Frequency Section)
Controls high frequency gain and cutoff frequency of the HF shelf filter.
Continuously variable gain, ±18 dB.