User Guide / Owners Manual

Waves Abbey Road Reverb Plates
User Guide
11
Analog
Controls the amount of modeled hum & noise added to the signal. To add the precise
amount of hum & noise delivered by the original plates, set the value to 100.
Range: Off to 100
Default: Off
Treble
4000-Hz High-shelf filter to control the reverb’s brightness.
Range: -20 dB to +20 dB
Default: 0 dB
PreDelay
Controls the amount of the delay between the dry and wet signal.
Range: 0 ms–500 ms
Default: 0 ms
Wet/Dry
Controls the balance between the dry and wet signal and thus the amount of reverb
added.
Range: 0% (dry) to 100% (wet)
Default: 100% (wet)
Crosstalk (Only in Stereo to Stereo component)
Controls the summing between the Left and Right inputs to get a stereo effect.
Range: 0%–100%
Default: 0%