Quick Start Guide

SoundGrid Servers / Quick Start Guide
3
How to Connect
A SoundGrid network consists, at minimum, of these elements:
Connect all components to a 1 Gb SoundGrid-compatible switch, using Cat 6 (or better) Ethernet cables. Use the
etherCON connector (all 2U height servers) or RJ45 connector (all 1U height servers) on the server’s rear panel. For a
list of SG- compatible switches, consult this Waves support page:
http://www.waves.com/support/network-switches-for-soundgrid-systems
Configuring a Server in the Host Application
Once the host computer, I/O devices, and the server are connected to the switch, turn on all the components and
launch the host application. The host will identity all network devices and ask you if you want to configure them.
Some hosts require you to click Auto-Config Start, which sets in motion the same configuration process. The host
will scan the network, assign devices, and patch the I/Os. You can also assign I/Os and servers manually. Please
refer to your host application for details.
I
MPORTANT
N
OTES
• The SoundGrid port is used to connect exclusively to the SoundGrid switch.
Do not use other networks, such as internet, on the SoundGrid network.
• USB3 and HDMI ports on a server are for service only.
SoundGrid host computer
1Gb Ethernet switch
SoundGrid server
SoundGrid I/O
Cat 6 (or better) Ethernet cables