Specifications

Audio Plug-Ins Guide542
The Master section doesn’t change when you
switch amps. Master section settings are stored
and recalled with plug-in presets.
Input LED
The Input LED shows green, yellow, orange, or
red to indicate whether you are under- or over-
driving the plug-in. The Input LED is before the
Input section of the Master section. To learn
more about the Input LED within the Eleven sig-
nal chain, see “Eleven Signal Flow Notes” on
page 559.
Input
The Input knob provides input trim/boost, for
tone and distortion control. The Input range is
–18 dB to +18 dB.
The Input knob provides a great way to increase
or decrease gain with amp models that don't
have a separate preamp control. It also provides
a way to trim or boost the level of pre-recorded
tracks you want to treat with Eleven
It is important to note that the setting of the In-
put knob is saved and restored with Settings
files (presets).
Output
The Output control sets the output gain after
processing, letting you make up gain or prevent
clipping on the channel where the plug-in is be-
ing used. Output range is –60 dB to +18 dB.
Amp Type
Amp Type selects which amplifier model to use
(see “Amp Types” on page 543).
Cab Type
This selector lets you select which speaker cabi-
net model to use (see “Eleven Cabinet Types” on
page 546).
Gate
Noise Gate Threshold
The Noise Gate Threshold control sets the level
at which the Noise Gate opens or closes. At min-
imum Threshold setting, the Noise Gate has no
effect. At higher Threshold settings, only louder
signals will open the Gate and pass sound.
Threshold range is from Off (–90 dB) to –20 dB.
Noise Gate Release
The Noise Gate Release control sets the length of
time the Noise Gate remains open and passing
audio. Adjust the Release to find the best setting
for the current task (not too fast to avoid cutting
off notes, and not too slow to avoid unwanted
noise). Release range is from 10 ms to 3000 ms.
Master section
To learn more about the Input control, see
“Eleven Signal Flow Notes” on page 559
Input
Gate
OutputAmp Type
Cab Type
When you want to adjust Eleven’s output
level, use the Output knob. For tone/distor-
tion, use the amp Master volume.