Specifications

Chapter 85: Xpand!2 471
To FX2 (FX2 Send to FX1)
This control lets you send a percentage of the
FX2 output signal into FX1, instead of directly
to the output. At 0%, no signal is sent to FX1. At
100%, all of the FX2 output signal is sent to FX1.
This is useful for cascading a delay effect into a
reverb for a more ambient effect, for example.
Xpand!
2
Patch Edit Controls
Overview
The Patch Edit parameter buttons provide ac-
cess to additional sets of controls where you can
edit the current patch in more detail. Click one
of the three following buttons so that it is lit to
edit its associated parameters:
Xpand!
2
Play Patch Edit
Controls
The Play controls let you set basic parameters
for the current part, including pitch transposi-
tion, keyboard splits, voicing behavior, and
pitch bend range.
Tr/Fine
The Tr/Fine (Transpose/Fine Tune) section in-
cludes two different controls for transposing in-
coming MIDI notes. The Semitone control (the
upper control) transposes incoming notes up or
down in semitones. For finer control, use the
Cents control (the lower control), which trans-
poses notes up or down in cents.
Click the control and drag up or down to in-
crease or decrease its value.
Hi/Lo Key
Use the Hi/Lo Key controls to assign Parts to dif-
ferent keyboard ranges. This can be useful for
splitting your keyboard across different Parts.
For example, Part A holding a bass sound could
be assigned C-1 to B2 and Part 2 your synth lead
assigned C3 to G8.
FX1 to FX2 knob
Button Controls
Play Mixer, Panning, FX Sends, MIDI
Arp Arpeggiator Settings
Mod Modulation Settings
Play parameters