Specifications

Audio Plug-Ins Guide344
To edit the Contour Line:
1 To move a breakpoint, click directly on it and
drag it to the desired position. Moving a break-
point higher increases noise reduction at that
range. Moving a breakpoint lower decreases
noise reduction at that range.
2 To move multiple breakpoints, Control-drag
(Windows) or Command-drag (Mac) to select
the desired breakpoints. Click the appropriate
Move Breakpoint button (below the Spectral
Graph) to move the selected breakpoints in 1 dB
increments. Control-Shift-drag (Windows) or
Command-Shift-drag (Mac) to extend your se-
lection.
3 To move the entire Contour Line, Control-drag
(Windows) or Command-drag (Mac) to select
the entire range. Click the appropriate Move
Breakpoint button (below the Spectral Graph) to
move the selected breakpoints in 1 dB incre-
ments. The higher you move the Contour Line
above the noise signature, the more noise is re-
moved.
4 To create a new breakpoint, click on the Con-
tour Line.
5 To delete a breakpoint, Alt-click (Windows) or
Option-click (Mac) the breakpoint. As long as
you click and hold the mouse, you will delete all
breakpoints that the cursor passes over.
Using BNR AudioSuite
BNR AudioSuite is identical to the real-time ver-
sion of BNR, with the addition of two features to
enhance the noise reduction process. These fea-
tures are:
Audition Lets you listen specifically to the noise
portion being removed from the target material.
This makes it easier to fine-tune noise reduction
settings to maximize noise reduction and mini-
mize signal loss.
Post-Processing Applies post-processing to the
audio file to help remove undesirable artifacts
that are a result of noise reduction.
To enable either of these features, click the cor-
responding button. To disable them, click again.
Dragging a breakpoint
Moving selected breakpoints
BNR AudioSuite