Specifications

Audio Plug-Ins Guide20
When monitoring in Band-Pass mode, the Fre-
quency and Q controls function differently.
Frequency Sets the frequency above and below
which other frequencies are cut off, leaving a
narrow band of mid-range frequencies.
Q Sets the width of the narrow band of mid-
range frequencies centered around the Fre-
quency setting.
To switch an EQ III control out of Band-Pass mode:
 Release Start+Shift (Windows) or Con-
trol+Shift (Mac).
Controlling EQ III from a Control
Surface
EQ III can be controlled from any supported
control surface, including our D-Control, D-
Command, ProControl, C|24, 003, Digi 002, or
Command|8. Refer to the guide that came with
the control surface for details.
EQ III I/O Controls
Certain Input and Output controls are found on
all EQ III configurations, except where noted
otherwise.
Input Gain Control
The Input Gain control sets the input gain of the
plug-in before EQ processing, letting you make
up gain or prevent clipping at the plug-in input
stage.
Output Gain Control
(7 Band EQ and 2–4 Band EQ Only)
The Output Gain control sets the output gain af-
ter EQ processing, letting you make up gain or
prevent clipping on the channel where the plug-
in is being used.
I/O controls and meters for 7 Band EQ and
2–4 Band EQ (top) and 1 Band EQ (bottom)
Input
Output Gain
Input and Output Meters
Gain
Input
Polarity
Clip
Indicators
Control
Control
Control