Specifications

Chapter 58: Reel Tape Flanger 287
Reel Tape Flanger Tips
To achieve a flanging effect, set the Range con-
trol within the “Flange” range and adjust the
LFO Depth control to a value that is greater than
the offset (so that the variable delay crosses the
“zero” point.)
To achieve an ADT (doubling) effect, set the
Range control within either of the “ADT” ranges
and adjust the LFO Depth control to a value that
is smaller than the offset (so that the variable
delay does not cross the “zero” point).
To achieve a manual flanging effect, set the
LFO Depth control to 0 and vary (or automate)
the Range control within the “Flange” range. For
fine control, hold Control (Windows) or Com-
mand (Mac) while varying the Range control.
To add complexity to flanging or ADT effects,
turn up the Wow/Flutter control to introduce
more fluctuation in the variable delay.
Use Reel Tape Flanger in a send/return config-
uration to mix the dry signal with an aggres-
sively driven, flanged signal to control the
amount ofgrunge” in the final mix.
When you start playback, the LFO sweep al-
ways starts at the bottom of the cycle, so each
time you start playback from the same location
(for example, at a bar line), the effect will be ap-
plied in the same way.
Reel Tape Flanger Presets
12-String
Moderate-depth ADT setting that
works well with acoustic guitar sounds
Flutter Flange
Moderate-depth flange setting
with Wow/Flutter
Flutter
Extreme Wow/Flutter setting with flang-
ing turned off and a Mix setting that passes only
the variable delay
Manual Flange
Settings with LFO Depth set to
zero, ready for manual flanging by adjusting or
automating the Range control
Slow Flange
High Depth setting combined with
slow LFO Rate, suitable for flanging vocals
Vocal ADT
Settings for creating doubling effect
without flanging “crossover” effect, suitable for
vocals
Vocal Walrus
Drive-boosted settings for extreme
vocal doubling effect
Wobble
A high LFO Rate setting combined with
a Mix setting that passes only the variable delay.
Works well on sustained parts.