Specifications

Audio Plug-Ins Guide286
Mix
The Mix control adjusts the amount of fixed de-
lay signal mixed with the variable delay signal in
the final output of the plug-in. The default Mix
value is adjustable from –100 (all fixed delay
signal) to +100 (all variable delay signal) per-
cent, with a default value of 0 (50% fixed delay,
50% variable delay signals).
Invert
(Plug-In Automation Playlist or Control
Surface Access Only)
The Invert parameter inverts the polarity of the
signal coming from the variable delay tape ma-
chine, so that complete audio cancellation oc-
curs when the flanger effect crosses the zero
point. The default setting for the Invert param-
eter is Off.
This parameter is accessible only from the plug-
in automation playlist or from a supported con-
trol surface.
Noise
(Plug-In Automation Playlist or Control
Surface Access Only)
The Noise parameter controls the level of simu-
lated tape hiss that is added to the processed sig-
nal. Noise is adjustable from Off (–INF) to
–24 dB, with a default value of Off.
This parameter is accessible only from the plug-
in automation playlist or from a supported con-
trol surface.
Synchronizing Reel Tape
Flanger to Session Tempo
You can set the LFO Rate in Reel Tape Flanger to
synchronize to the session tempo (in beats per
minute).
To synchronize the LFO Rate control setting to the
session tempo:
1 In the BPM Sync section, click the On button.
The Tempo/Rate display changes to synchronize
with the current session tempo.
2 To set a rhythmic LFO rate, click the Note
Value to choose from the available note values
(whole, half, quarter, eighth, sixteenth, or
thirty-second note)
3 To adjust the rhythm further, do any of the fol-
lowing:
• To enable triplet rhythm delay timing, click
the Triplet (“3”) button so that it is lit.
• To set a dotted rhythm delay value, click the
Dot (“.”) button so that it is lit.
Settings for this parameter are saved with
plug-in presets. If you use a preset for the
TDM, RTAS or AudioSuite version of this
plug-in, any settings for this parameter
will be active.
Settings for this parameter are saved with
plug-in presets. If you use a preset for the
TDM, RTAS or AudioSuite version of this
plug-in, any settings for this parameter
will be active.
BPM Sync controls
Tempo/Rate
Triplet
button
On
button
Dot
button
Note Value
display
display