Specifications

Audio Plug-Ins Guide270
Mix Adjusts the balance between the effected
signal and the original signal and controls the
depth of the effect. Mix is adjustable from 0% to
100%.
Low Pass Filter Controls the cutoff frequency of
the Low Pass Filter. Use this to attenuate the
high frequency content of the feedback signal.
The lower the setting, the more high frequencies
are removed from the feedback signal.
The range of the Low Pass Filter is 20 Hz to
19.86 kHz, with a maximum value of Off (which
effectively means bypass).
Delay Sets the delay time between the original
signal and the chorused signal. The higher the
setting, the longer the delay and the wider the
chorusing effect. Delay is adjustable from 0–20
milliseconds.
LFO Rate Adjusts the rate of the LFO (low fre-
quency oscillator) applied to the delayed signal
as modulation. The higher the setting, the more
rapid the modulation. You can select either a
sine wave or a triangle wave as a modulation
source, using the LFO Waveform selector.
LFO Width Adjusts the intensity of the LFO ap-
plied to the delayed signal as modulation. The
higher the setting, the more intense the modula-
tion. Use the LFO Waveform selector to select a
sine or a triangle wave as a modulation source.
Feedback Controls the amount of feedback ap-
plied from the output of the delayed signal back
into its input. Negative settings provide a more
intense effect.
LFO Waveform Selects a sine wave or triangle
wave for the LFO. This affects the character of
the modulation. The sine wave has a gentler
ramp and peak than the triangle wave.