Specifications

Audio Plug-Ins Guide266
Mode
Select one of the following options for the type
of filter:
LP24 Provides a low pass filter with a 24 dB cut-
off.
LP18 Provides a low pass filter with a 18 dB cut-
off.
LP12 Provides a low pass filter with a 12 dB cut-
off.
BP Provides a band pass filter.
HP Provides a high pass filter.
Output
The Output control lets you lower the Output
level from 0.0 dB to –INF dB.
Vintage Filer Envelope Section
Controls
The Filter effect provides an Envelope follower
for controlling the Cutoff frequency. The Enve-
lope section offers control over the envelope’s
shape and depth of modulation.
Attack
Adjust the Attack control to set the time
(10.0 ms to 10 seconds) it takes to respond to in-
creases in the audio signal level.
Release
Adjust the Release control to set the time
(10.0 ms to 10 seconds) it takes to recover after
the signal level falls.
Depth
Adjust the Depth control to determine how
much the Envelope follower affects the Cutoff
frequency.
 At 0%, the Envelope follower has no effect on
the Cutoff frequency.
 At +100%, the Attack ramps up to the Cutoff
frequency setting; and the Release starts from
the Cutoff frequency setting and ramps down.
 At –100%, the Attack starts from the Cutoff
frequency setting and ramps down; and the Re-
lease ramps up to the Cutoff frequency setting.
Vintage Filer LFO Section
Controls
The Filter effect provides a sinusoidal Low Fre-
quency Oscillator (LFO) for modulating the fil-
ter cutoff frequency. The LFO section offers con-
trol over the rate, depth and synchronization of
the modulation.
Rate
Adjust the Rate control to increase or decrease
the frequency (0.01–100.0 Hz) of the LFO.
Lower settings are slower and higher settings
are faster. When Sync is on, the Rate knob
switches from counting in milliseconds, to
rhythmic values.
Depth
Adjust the Depth control to increase (or de-
crease) the amount of modulation (0–100%) of
the Cutoff frequency by the LFO. Lower settings
create a slight vibrato (with the rate set high)
and higher settings create a wide sweep of the
Cutoff frequency range.
Sync
Click the Sync button to synchronize the LFO
with the session tempo.