Specifications

Audio Plug-Ins Guide262
Depth
The Depth control lets you adjust the depth of
modulation, which in turn affects the amount of
phasing applied to the audio signal.
Feedback
The Feedback control feeds the output signal of
Phaser back into the input, creating a resonant
or singing tone in the phaser when set to its
maximum.
Mix
The Mix control lets you adjust the Mix between
the “wet” (effected) and “dry” (unprocessed)
signal. 0% is all dry, and 100% is all wet, while
50% is an equal mix of both.
Low Cut
The Low Cut control lets you adjust the fre-
quency of the Low Cut Filter in the phaser’s
feedback loop. This can be useful for taming low
frequency “thumping” at high feedback settings.
Phaser Section Controls
The Phaser section provides control over the ef-
fect’s center frequency and number of phaser
stages (or Poles).
Center
The Center control lets you change the fre-
quency center (100 Hz to 10.0 kHz) for the
phaser poles.
Poles
Select the number of phaser poles (stages): 2, 4,
6, or 8. The number of poles changes the charac-
ter of the sound. The greater the number of
poles, the thicker and squishier the sound.
Phaser LFO Section Controls
The LFO section provides control over the wave-
form and stereo offset of the LFO.
Wave
The Wave control lets you interpolate between a
triangle wave and a sine wave for modulating
the Phaser.
L/R Phase
The L/R Phase control lets you adjust the rela-
tive phase of the LFO modulation applied to the
left and right channels.