Specifications

Chapter 40: Reel Tape Delay 239
Wow/Flutter
The Wow/Flutter control adjusts the amplitude
of the tape machine’s wow and flutter, or the
amount of fluctuation in tape speed. A higher
setting results in wider fluctuations in speed. A
lower setting results in narrower fluctuations in
speed. Wow/Flutter is adjustable from 0 to
1 percent, with a default value of 0.20 percent.
Wow Speed
(Plug-In Automation Playlist or
Control Surface Access Only)
The Wow Speed parameter adjusts the fre-
quency of the tape machine’s wow effect, or the
rate of fluctuation in tape speed. A higher value
results in faster fluctuations in speed. A lower
value results in slower fluctuations in speed.
Wow Speed is adjustable from 0 to 100 percent,
with a default value of 50 percent.
This parameter is accessible only from the plug-
in automation playlist or from a supported con-
trol surface.
Bass
The Bass control boosts or cuts the amount of
low frequencies fed to the echo feedback loop.
Bass amount is adjustable from –10 dB to
+10 dB, with a default value of 0 dB.
Treble
The Treble control boosts or cuts the amount of
high-mid frequencies fed to the echo feedback
loop. Treble amount is adjustable from –10 dB
to +10 dB, with a default value of 0 dB.
Mix
The Mix control adjusts the amount of pro-
cessed signal mixed with the input signal in the
final output of the plug-in. The default Mix
value is 25 percent.
Noise
(Plug-In Automation Playlist or Control
Surface Access Only)
The Noise parameter controls the level of simu-
lated tape hiss that is added to the processed sig-
nal. Noise is adjustable from Off (–INF) to
–24 dB, with a default value of –80 dB.
This parameter is accessible only from the plug-
in automation playlist or from a supported con-
trol surface.
Settings for this parameter are saved with
plug-in presets. If you use a preset for the
TDM, RTAS or AudioSuite version of this
plug-in, any settings for this parameter
will be active.
Note that this control does not affect the
first delayed signal, only the repeated de-
lays caused by the Feedback control.
Note that this control does not affect the
first delayed signal, only the repeated de-
lays caused by the Feedback control.
Settings for this parameter are saved with
plug-in presets. If you use a preset for the
TDM, RTAS or AudioSuite version of this
plug-in, any settings for this parameter
will be active.