Specifications

Chapter 36: Mod Delay III 229
For example, selecting a quarter note and then
selecting the dot indicates a dotted quarter note,
and selecting an eighth note and then selecting
the triplet indicates a triplet eighth note.
Groove
The Groove control provides fine adjustment of
the delay in percentages of a 1:4 subdivision of
the beat (from –100% to 100%). It can be used to
add “swing” by slightly offsetting the delay from
the precise beat of the track.
Modulation Section
Rate
The Rate control sets the rate of modulation of
the delayed signal (from 0.00 Hz to 20.0 Hz).
Depth
The Depth control sets the depth of the modula-
tion applied to the delayed signal (from 0% to
100%).
Mix
The Mix control sets the balance between the de-
layed signal (wet) and the original signal (dry).
If you are using a delay for flanging or chorus-
ing, you can control the depth of the effect
somewhat with the Mix setting. Click the Dry
button to set the Mix to 100% dry. Click the Wet
button to set the Mix to 100% wet.
Output
The Output section provides output metering
and controls for adjusting the level of the output
signal.
Output Meters
The Output meters show peak signal levels after
processing:
Dark Blue
Indicates nominal levels from –INF to
–12 dB.
Light Blue
Indicates pre-clipping levels, from
–12 dB to 0 dB.
Red
Indicates full scale levels (clipping)
Output Gain
The Output Gain control sets the output level af-
ter processing. For mono instances of Mod De-
lay III, there is a single Gain control. For stereo
and mono-to-stereo instances of Mod Delay III,
there are independent Gain controls for each
channel (left and right).
Selections for Mod Delay III
AudioSuite Processing
Because AudioSuite Delay adds additional mate-
rial (the delayed audio) to the end of selected
audio, make a selection that is longer than the
original source material to allow the additional
delayed audio to be written to the end of the au-
dio file.
If you select only the original material without
leaving additional space at the end, delayed au-
dio that occurs after the end of the selection to
be cut off.
Duration buttons