Specifications

Audio Plug-Ins Guide224
Mod Delay II Controls
Mod-Delay II provides a variety of controls for
adjusting plug-in parameters.
Mod Delay II Gain Control
This control controls the input level to the delay
to prevent clipping.
Mod Delay II Mix Control
This control controls the balance between the
delayed signal (wet) and the original signal
(dry). If you are using a delay for flanging or
chorusing, you can control the depth of the ef-
fect somewhat with the Mix setting.
Mod Delay II LPF (Low Pass
Filter)
Controls the cutoff frequency of the Low Pass
Filter. Use the LPF setting to attenuate the high
frequency content of the feedback signal. The
lower the setting, the more high frequencies are
attenuated. The maximum value for LPF is Off.
This lets the signal pass through without limit-
ing the bandwidth of the plug-in.
Mod Delay II Delay Control
This control sets the delay time between the
original signal and the delayed signal.
Mod Delay II Depth Control
This controls the depth of the modulation ap-
plied to the delayed signal.
Mod Delay II Rate Control
This control controls the rate of modulation of
the delayed signal.
Mod Delay II Feedback Control
This control controls the amount of feedback
applied from the output of the delay back into
its input. It also controls the number of repeti-
tions of the delayed signal. Negative feedback
settings give a more intense “tunnel-like” sound
to flanging effects.
Mod Delay II Tempo Sync
Control
Tempo sync provides a direct connection be-
tween the Pro Tools session tempo and plug-in
controls that support MIDI Beat Clock (such as
Delay). This direct connection lets plug-in pa-
rameters such as delay, automatically synchro-
nize to, and follow changes in, session tempo.
When Tempo Sync is enabled, the Tempo and
Meter controls are uneditable and follow the
session tempo and meter changes. The Duration
and Groove controls apply when Tempo Sync is
enabled.
To enable Tempo Sync:
 Click the Tempo Sync icon. The tempo shown
changes to match the current session tempo and
the meter changes to match the current meter.
Tempo Sync icon