Specifications

Audio Plug-Ins Guide222
From and To
The From and To controls let you feed signal
from one delay Tap to another, or back to the
main input, to create complex delay/feedback
effects.
From
The From control sets the tap from which signal
will be cross-routed.
To
The To control sets the tap (or the main input)
that the cross-routed signal will be routed to.
High Cut
The High Cut control lets you adjust the fre-
quency for the High Cut filter. For less treble,
lower the frequency.
Low Cut
The Low Cut control lets you adjust the fre-
quency for the Low Cut filter. For less bass, raise
the frequency.
Mix
The Mix control lets you balance the amount of
dry signal with the amount of wet (delayed) sig-
nal. At 50%, there are equal amounts of dry and
wet signal. At 0%, the output is all dry and at
100% it is all wet.
Multi-Delay Delay Taps Controls
The Multi-Delay provides five Taps (delay
lines). Each Tap provides the same set of con-
trols. Controls for each Tap can be edited inde-
pendently of the other Taps. Each Tap provides
the following controls:
On
The On button turns the selected tap’s signal on
or off.
Delay
Adjust the Delay control to set the length of de-
lay for the tap, relative to the main Delay set-
ting.
Level
Adjust the Level control to change the output
level of the Tap.
Pan
Adjust the Pan control to pan the audio signal
from the Tap left or right in the stereo field.
If the delay time of the “To” tap is greater
than the delay time of the “From” tap, then
the result is “feed-forward” rather than
feedback, so only one delay repeat will be
heard.