Specifications

Audio Plug-Ins Guide218
Select from the following rhythmic values:
• 16 (sixteenth note)
• 8T (eighth-note triplet)
• 16D (dotted sixteenth-note)
•8 (eighth note)
• 4T (quarter-note triplet)
• 8D (dotted eighth-note)
•4 (quarter note)
•2T (half-note triplet)
• 4D (dotted quarter-note)
•2 (half note)
• 1T (whole-note triplet)
• 3/4 (dotted half note)
•4/4 (whole note)
• 5/4 (five tied quarter notes)
• 6/4 (dotted whole note)
• 7/4 (seven tied quarter notes)
• 8/4 (double whole note)
When Sync is disabled, the Time control lets you
set the delay time in milliseconds and seconds
(1 ms to 4.00 seconds).
Feedback
The Feedback control lets you adjust the amount
of delay feedback. At 0% the delayed signal re-
peats only once. As you increase the feedback,
the number of times the delay repeats increases.
At 100%, the delay doesn’t repeat indefinitely,
but it does last a very long time!
Note that each Delay mode produces a different
feedback pattern, especially when the L/R Ratio
control is not centred.
Mix
The Mix control lets you balance the amount of
dry signal with the amount of wet (delayed) sig-
nal. At 50%, there are equal amounts of dry and
wet signal. At 0%, the output is all dry and at
100% it is all wet.
Dynamic Delay Delay Section
The delay section of the Dynamic Delay plug-in
provides L/R Ratio and Stereo Width controls.
L/R Ratio
The Left/Right Ratio control lets you set the ra-
tio of left to right delay times. Move the control
all the way to the left (50:100) and the left chan-
nel delay time is half the right channel delay
time. Move the control all the way to the right
(100:50) the right channel delay time is half the
left channel delay time.
Stereo Width
The Stereo Width control lets you adjust the
width of the delay effect in the stereo field.
Dynamic Delay EQ Section
The EQ section of the Dynamic Delay plug-in
provides low and high cut filters.
Low Cut
The Low Cut control lets you adjust the fre-
quency for the Low Cut filter. For less bass, raise
the frequency.
High Cut
The High Cut control lets you adjust the fre-
quency for the High Cut filter. For less treble,
lower the frequency.