Specifications

Chapter 32: TL Space TDM and TL Space Native 211
Width
Increase or reduces the stereo spacious-
ness of the reverb. Use this control to tailor the
reverb’s character in a mix. Keep in mind that an
IR that has little stereo separation to begin with
may have limited results.
Balance
Controls the balance of the reverb out-
put. Use this control to balance a reverb from an
IR that has been captured without a centered
stereo image, or for creatively controlling the
character of the reverb in a mix.
Reverse
Reverses the IR waveform and controls
the total length. As the IR waveform is recalcu-
lated, it is re-displayed in the Waveform display.
The value shown is measured in Beats Per Min-
ute to let you easily match the tempo of the mu-
sic.
TL Space Decay Section
Controls
The Decay group controls allow the user to con-
trol the decay of the low, mid, and high fre-
quency portions of the IR. Use the controls to
tailor the reverb’s character for a mix or for cre-
ative possibilities not found in traditional re-
verb processors.
Low
Decreases or increases the rate at which low
frequencies decay.
Low Xover
Adjusts the frequency point that di-
vides the IR into low and mid frequency por-
tions.
Mid
Decreases or increases the rate at which mid
frequencies decay.
High Xover
Adjusts the frequency point that di-
vides the IR into mid and high frequency por-
tions.
High
Decreases or increases the rate at which
high frequencies decay.
Front/Rear
In quad and 5.0 channel output
modes, Front and Rear independently control
the decay for front and rear channels.
TL Space Info Screen
Click the Trillium Lane Labs logo to view the
Info screen. The Info screen displays copyright
and version information.
If the waveform is reversed using the Re-
verse control, effected audio may continue
to play for several seconds after the trans-
port is stopped or audio input finishes.