Specifications

Audio Plug-Ins Guide176
When Pre-Delay Link is enabled, negative early
reflection Pre-Delay times can be used to make
the early reflections start before the reverb tail,
if desired.
Pre-Delay Link Button
The Pre-Delay Link button toggles linking of the
Early Reflection Pre-Delay control and the Re-
verb Pre-Delay control. When linked, the Early
Reflection Pre-Delay is offset by the Reverb Pre-
Delay amount, so that the total delay for the
early reflections is the sum of the Early Reflec-
tion Pre-Delay and the Reverb Pre-Delay.
ER On/Off Button
This button toggles early reflections on or off.
When early reflections are off, the reverb effect
consists entirely of reverb tail.
ReVibe Levels Section Controls
The Levels section has controls for adjusting
source input and ReVibe output levels. ReVibe
provides individual output level controls for
front, center, rear reverb, and rear early reflec-
tions.
In stereo and greater-than-stereo formats where
there is no center channel or where there are no
rear channels, the center and rear level controls
can be used to augment the reverb sound. Re-
verb and early reflections that would be heard
either from the center channel or from the rear
channels can be mixed into the front left and
right channels.
Input Control
Input adjusts the level of the source input to
prevent internal clipping. The range of this con-
trol is from –24.0 dB to 0.0 dB. Lowering the In-
put control does not change the levels shown on
the input side of the Input/Output meter, which
shows the level of the signal before the Input
control.
Pre-Delay Link button
ER On/Off button
Levels controls