Specifications

Chapter 26: AIR Non-Linear Reverb 147
Chapter 26: AIR Non-Linear Reverb
AIR Non-Linear Reverb is an RTAS plug-in. Use
the Non-Linear Reverb plug-in to apply special
gated or reversed Reverb effects to the audio sig-
nal, creating a synthetic, processed ambience.
Reverse
The Reverse button turns Reverse mode on and
off. In Reverse mode, the tail of the reverb signal
fades up to full volume, then disappears, rather
than fading out.
Pre-Delay
The Pre-Delay control determines the amount of
time that elapses between the original audio
event and the onset of reverberation.
Dry Delay
The Dry Delay control applies a specified
amount of delay to the dry portion of the signal,
which can create a “reverse reverb” effect, where
the reverb tail is heard before the dry signal.
Reverb Time
Adjust the Reverb Time to change the length of
the reverberation’s decay.
Mix
The Mix control lets you adjust the Mix between
the “wet” (processed) and “dry” (unprocessed)
signal. 0% is all dry, and 100% is all wet, while
50% is an equal mix of both.
Non-Linear Reverb Reverb
Section Controls
The Reverb section provides control over the re-
verb’s diffusion and stereo width.
Diffusion
Adjust the Diffusion control to change the rate
at which the sound density of the reverb tail in-
creases over time. Higher Diffusion settings cre-
ate a smoother reverberated sound. Lower set-
tings result in more fluttery echo.
Width
The Width control lets you widen or narrow the
effect’s stereo field.
Non-Linear Reverb plug-in window