User guide

2.3. Mixer Tab
The mixer tab provides the ability to set the levels of impulse responses and cross-fade between
them. VU meters are provided to give an indication of signal level.
LFO
The LFO controls the speed of modulation of all the controls featuring modulation on the mixer tab.
A control for applying the panning and mix modulation before or after the IR convolution processes
is provided.
IR1 and IR2
Independent gain and pan controls are provided for both IR1 and IR2. The Pan Mod control allows
the panning to be modulated using the LFO. The phase of the modulation allows the user to
independently control the position of the panning of the impulse responses relative to each other.
For example if the pan of IR1 is centre, and a fully modulated pan of IR1 is currently dragging the
panning hard left, replicating these settings on IR2 with a pan of 180 degrees will result in a pan of
hard right at the same instant. This allows the user to produce effects where the panning of one IR
follows or opposes the panning of another.