Manny Marroquin Delay User Guide / Owners Manual

Waves Manny Marroquin Delay
User Guide
- 8 -
FDBK L/FDBK R determines the amount of feedback per channel.
Range: 0 – 100%
LINK determines whether or not channel settings are linked or independently controlled.
When Link Mode is selected (On), left channel settings are applied to the right channel
as well. Once linked, previous right channel settings are not restored when unlinked.
Range:
 On (left and right channel settings ar
e linked)

Off (left and right channel settings are independe
ntly controlled)
DRY/WET controls the balance between the direct and Delay + HP/LP paths. (See
signal flow diagram.) Reverb, Distortion, Doubler and Phaser are not affected, so that
they may be used without the Delay if desired.
Range: 0 – 100%
HP/LP controls the cutoff frequency of the HP and LP filters. This process is on the
Delay path, so if you apply a HP or LP and set the Dry/Wet to 0, the HP/LP will not affect
the dry signal.
HP: 16 Hz – 21357 Hz, Off (all the way counter-clockwise)
LP: 21357 Hz – 16 Hz, Off (all the way clockwise)
HP/LP LINK inversely links HP and LP controls to create a simultaneous opening and
closing filter effect on the delay. For example: When HP/LP Link is selected, if the LP is
set to 8 kHz and the HP is set to 150 Hz, moving the HP to 600 Hz will simultaneously
move the LP to 1990 Hz, creating a closing filter.
Please note: Once the controls reach the same frequency (HP = 1 kHz and LP =1 kHz),
the controls lock and may not be moved forward, only backward.
VERB SIZE controls the size of the reverb.
Range: 0 – 100
VERB LEVEL controls the level of the reverb.
Range: 0 – 100