User Guide

Waves IR-1 software guide page 21
The RT60 display is active only when RT60 may be computed on the IR. There is a
minimum IR length (about 100 ms) for computing RT60 as well as for activating the reverb
time ratio.
Reverb Control Parameters
SIZE: Range: 0.25 to 4.00; Default: 1.00
The Size is a ratio of the original IR, and controls the dimensions and volume of the actual
room. This defines the traveling time of sound between reflections. The Size value will be
indicated in the IR Properties display.
REVERB DENSITY: Range: 0.25 to 4.00; Default: 1.00
The Density control is a ratio of the density in the original IR. Reducing density will usually
result in a more grainy sound; increasing density will usually create a thicker and smoother
sound. The outcome will vary according to the nature of the reflections in the original
reverb.
REVERB RESONANCE: Range: 0.25 to 4.00; Default: 1.00
Resonance extends or reduces any existing resonances in the original IR.
DECORRELATION CONTROL: Range: 0 to 100%. Default = 0%
The Decorr control increases spaciousness by increasing the Decorrelation between
channels.
You can use this control to make a stereo output out of a mono-recorded IR. To
achieve this, load a single-channel IR into a stereo or mono ד stereo plugin component.
Then, cancel the "import” dialog when the plugin asks for the second channel.