User Guide

Chapter 2 – Quickstart Guide

Turn the large threshold knob clock wise until you distinctly hear compression
occurring. At that point, the VU Meter set to GR should show display activity.
 Use the Ratio control to adjust the amount of compression. Higher ratio equals
more compression

Use the Attack control to set the speed at which compression will occur.

If you lose any transient information, use the Punch control to bring them back.

Use the Release control to set the speed at which the compression fades out.

Choose Host or BPM Sync mode if you want the compression to correspond to
your track tempo.
 Once you’ve set the correct compression, use the Mix control to blend the
compressed signal in with the original input.

At this point. experiment with the Analog Modes to change the sonic character of
the compressor

To control output levels, use the Output Trim control, and activate the Limiter as
needed.
Waves H-Comp Hybrid Compressor
User Guide
5