User Guide
Table Of Contents
- About Waves eMotion LV1
- Installation and Setup
- Top Bar
- Floating Windows
- System Inventory Page
- Using the System Inventory Page
- Mixer Settings Page
- User Interface Settings Page
- Patch Window Sections
- The Patch Grid
- Channels and Presets
- Channel Window Sections
- Input Section
- Plugin Rack Section
- Adding and Managing Plugins
- Plugin Pane
- Main Control Section
- AUX/EFX and AUX/MON Sends Section
- Channel Output Section
- Talkback
- Matrix
- Link Channel Controls (DCAs)
- Mixer Layers
- Top Bar
- Factory Mixer Layers and Custom Layers
- Mixer Channels
- Layer Modes
- Master Fader
- Utility Sections
- Scenes Page
- Scope Section
- Chapter 6: eMotion LV1 SIGNAL FLOW DIAGRAMS
- APPENDIX A: eMOTION LV1 MIXER CONFIGURATIONS
- APPENDIX B: USING MULTIPLE DISPLAYS
- Display specifications
- Single Display
- Two Displays: One for the Mixer Window, One for Other Windows
- Three Displays: Mixer, Show, and Patch/Setup/Channel Windows
- Two Displays: One Continuous Mixing Desk
- Three Displays: One Continuous Mixing Desk and a Large Control Section
- Single Large Display, Tiled Mixer Windows
- Four displays: One Continuous Mixing Desk, Two Control Monitors
- APPENDIX C: INCORPORATING MIDI
- APPENDIX D: MACKIE CONTROL PROTOCOL
- APPENDIX E: USING THE MIDIPLUS FIT CONTROLLER
- APPENDIX F: DELAY GROUPS
- eMotion LV1 KEYBOARD SHORTCUTS
190
Waves eMotion LV1 User Guide | Chapter 5: Show Window
Recall Safe Page
The Recall Safe page prevents changes to specified channels, busses, and functions during a scene change. An item that is in
Recall Safe mode is exempt from changes. Recall Safe is set for an entire session, not by scene. So once Recall Safe is set for the
parameters and channels of a session, scene recalls will not affect their settings.
The Recall Safe panel is identical to the Scope section in the Scene page. Selections are organized by channel functions and
plugins, input channels, groups and controls. Audio channels and busses can be made recall-safe from this panel, as well as from
the drop- down Preset menu for that channel. As with the Scope page, there is an All/None button that selects and de-selects all
parameters and channels.