User Guide

118
Waves eMotion LV1 User Guide | Chapter 3: Channel
7. Value box
Indicates the value of the selected control.
Panner/Balance/Rotator control: Mono panner position, stereo panners, stereo width, stereo rotation value. Fader:
Position is shown then when the fader is touched.
8. Peak level indicator
Displays channel peak level and clipping. Clip threshold, clip hold, and peak hold are set in the U/I Settings page (Setup
> U/I Settings > Peak and Clip).
9. Link/DCA assignments
A channel can be assigned to up to 16 Link groups, each of which provides linked control over multiple channels. A Link
Group couples a channel’s panner/balance/rotation, mute, cue/solo, trim, polarity, and preamp controls with equivalent
controls in other channels. A Link/DCA fader remotely controls the trim value of a group of assigned faders. (See Mixer >
Link/DCA Layer)
10. Channel fader
Sets channel gain main mix output—one fader for mono or stereo channel. Faders under the control of a DCA do not
move. They stay at their original position, while a “ghost fader” shows the current channel level as determined by the Link
group DCA fader. Post-fader and post-pan signal sources are both affected by this fader.
Range: -144 dB to +10 dB
11. Meter
Stereo or mono peak meter. Range: -INF to +10 dBFS
Infinite-hold peak indicator. Click anywhere on the meter to clear. Pre- and post-fader meter status is set at Setup > U/I
Settings.
12. Mute group assignment
Assigns the channel to up to eight mute groups. Mute groups are recalled in the Mix window or from a control surface.
13. Show keyboard
Accesses the operating system’s touch-screen keyboard. Use this to enter text information on a touchscreen display when
a hardware keyboard is not available. Alt and Ctrl modifier keys provide additional keyboard functionality. These keys are
latching; click again to release.