User Guide
Table Of Contents
- About Waves eMotion LV1
- Installation and Setup
- Top Bar
- Floating Windows
- System Inventory Page
- Using the System Inventory Page
- Mixer Settings Page
- User Interface Settings Page
- Patch Window Sections
- The Patch Grid
- Channels and Presets
- Channel Window Sections
- Input Section
- Plugin Rack Section
- Adding and Managing Plugins
- Plugin Pane
- Main Control Section
- AUX/EFX and AUX/MON Sends Section
- Channel Output Section
- Talkback
- Matrix
- Link Channel Controls (DCAs)
- Mixer Layers
- Top Bar
- Factory Mixer Layers and Custom Layers
- Mixer Channels
- Layer Modes
- Master Fader
- Utility Sections
- Scenes Page
- Scope Section
- Chapter 6: eMotion LV1 SIGNAL FLOW DIAGRAMS
- APPENDIX A: eMOTION LV1 MIXER CONFIGURATIONS
- APPENDIX B: USING MULTIPLE DISPLAYS
- Display specifications
- Single Display
- Two Displays: One for the Mixer Window, One for Other Windows
- Three Displays: Mixer, Show, and Patch/Setup/Channel Windows
- Two Displays: One Continuous Mixing Desk
- Three Displays: One Continuous Mixing Desk and a Large Control Section
- Single Large Display, Tiled Mixer Windows
- Four displays: One Continuous Mixing Desk, Two Control Monitors
- APPENDIX C: INCORPORATING MIDI
- APPENDIX D: MACKIE CONTROL PROTOCOL
- APPENDIX E: USING THE MIDIPLUS FIT CONTROLLER
- APPENDIX F: DELAY GROUPS
- eMotion LV1 KEYBOARD SHORTCUTS
113
Waves eMotion LV1 User Guide | Chapter 3: Channel
Aux faders and panners are color-coded to match the INP/PRE/PST/PSP source selection. The function of the aux panner
depends on the format of the source channel and the aux channel, as well as the send source selection.
When the source fader is at minus infinity and the send is switched off, moving the fader will turn the send on once again. We
assume that if you move the fader you likely want to turn on the send. This saves a step.