User Guide

100
Waves eMotion LV1 User Guide | Chapter 3: Channel
If the total track latency exceeds 4000 samples, a warning is displayed at the top of the rack. The
destination track may not be able to compensate for such a large latency.
eMotion LV1 latency compensation is discussed in detail in Appendix E.
EXTERNAL INSERTS
You can add external inserts to a plugin rack. An
external insert follows the same routing path as
plugins and can be moved up and down the rack to
change its position in the processing chain. Follow
these steps:
1. Choose a rack slot.
2. Select External Inserts from the Plugin Menu.
3. Choose an available insert from the menu. This opens the External Insert control page.
4. Select physical send and return I/Os using the drop-down menus.
5. Use the Device cell to rename the insert, if desired. Use the Insert drop-down menu to move between inserts.
If no send is assigned, then the insert will be bypassed. It remains in the rack and its place in the processing
chain is unchanged. If no return is assigned, then any other source assigned to this insert return will be heard.
A mono/stereo full-scale meter shows the level of the return signal This helps to maintain proper levels on sends and
returns.
The Latency knob is used to adjust the amount of delay to and from the external insert device. Unlike a plugin, an
external insert doesn’t declare its delay to the plugin-buss latency compensation engine, so this must be done
manually.
For more information, please refer to the External Insert Plugin User Guide, which can be found on the Waves Downloads page.