SoundGrid Studio User Guide / Owners Manual
Table Of Contents
- Welcome to SoundGrid Studio
- Part 1: Getting Started
- Part 2: Top Bar
- Part 3: Setup Window
- Setup Window Overview
- Network Controls
- Device Racks: Assigning and Managing Network Devices
- I/O Devices Racks
- I/O Device Racks Displays and Controls
- I/O Devices Menu Items
- SG Connect
- I/O Sharing
- Connected Systems
- System Inventory in Super Systems
- Sharing a Device
- Setting up Device Sharing
- Shared Devices: Clocking Considerations
- Patching Shared Devices
- Patching Shared Output Devices
- Shared and Un-Shared Devices in the Patch
- Removing Shared Devices
- If the Sharing Host Becomes Unavailable
- Share Preamp Control
- Servers
- External Control Devices
- Setting Sample Rate
- Assigning I/O Devices Manually
- Working Offline
- Mixer Settings
- User Interface Settings Section
- Patch Window Sections
- The Patch Grid
- Mixer Layers
- Mixer Channels
- Mixer Layer Modes
- Using Plugins
- Monitor Panel
- INCORPORATING MIDI
- MACKIE CONTROL PROTOCOL
- Setting Up Mackie HUI in a DAW
- Setup Window Overview
- Part 4: Patch Window
- Part 5: Mixer Window
- Appendix
Part 5: Mixer Window
SoundGrid Studio/ User Guide
88
Monitor Switching Under DAW Command
StudioRack can follow commands from the host DAW to switch automatically from Playback to Input state and back. To accept
these commands, StudioRack uses a virtual HUI device. This device is installed automatically to the computer, but it must be
connected manually to the DAW. This allows low-latency recording and monitoring of overdub tracks using preprogrammed
DAW in-points and out- points.
To enable this functionality, configure the DAW to send MIDI commands to StudioRack. Once selected as a MIDI controller,
StudioRack will await record status commands from the DAW. No setup is necessary in StudioRack.
S
ETTING UP A MACKIE HUI IN A DAW
Setting up MIDI controller using HUI protocol varies from one
DAW manufacturer to another. It consists of selecting a HUI
protocol virtual controller and then assigning Waves SoundGrid,
StudioRack to “Receive From” and Send To.” SuperRack does
not need additional configuration.
This example shows assigning a HUI-type controller in the Peripherals page of Pro Tools. Controller configuration varies by
DAW manufacturer. Please refer to the Appendix
for details.