SoundGrid Studio User Guide / Owners Manual
Table Of Contents
- Welcome to SoundGrid Studio
- Part 1: Getting Started
- Part 2: Top Bar
- Part 3: Setup Window
- Setup Window Overview
- Network Controls
- Device Racks: Assigning and Managing Network Devices
- I/O Devices Racks
- I/O Device Racks Displays and Controls
- I/O Devices Menu Items
- SG Connect
- I/O Sharing
- Connected Systems
- System Inventory in Super Systems
- Sharing a Device
- Setting up Device Sharing
- Shared Devices: Clocking Considerations
- Patching Shared Devices
- Patching Shared Output Devices
- Shared and Un-Shared Devices in the Patch
- Removing Shared Devices
- If the Sharing Host Becomes Unavailable
- Share Preamp Control
- Servers
- External Control Devices
- Setting Sample Rate
- Assigning I/O Devices Manually
- Working Offline
- Mixer Settings
- User Interface Settings Section
- Patch Window Sections
- The Patch Grid
- Mixer Layers
- Mixer Channels
- Mixer Layer Modes
- Using Plugins
- Monitor Panel
- INCORPORATING MIDI
- MACKIE CONTROL PROTOCOL
- Setting Up Mackie HUI in a DAW
- Setup Window Overview
- Part 4: Patch Window
- Part 5: Mixer Window
- Appendix
Part 5: Mixer Window
SoundGrid Studio/ User Guide
80
Move the DCA fader to change the gain offset of all the faders under its control. When
you move a DCA fader, the controlled faders don’t move. They stay at their original
positions, while “ghost faders” show the current channel level, as determined by the
offset introduced by the DCA fader. This makes it easier to return the faders in the link
group to their previous positions.
The Link layer is made up of the 16 Link faders. From here, you can
control each of the link groups.