SoundGrid Studio User Guide / Owners Manual
Table Of Contents
- Welcome to SoundGrid Studio
- Part 1: Getting Started
- Part 2: Top Bar
- Part 3: Setup Window
- Setup Window Overview
- Network Controls
- Device Racks: Assigning and Managing Network Devices
- I/O Devices Racks
- I/O Device Racks Displays and Controls
- I/O Devices Menu Items
- SG Connect
- I/O Sharing
- Connected Systems
- System Inventory in Super Systems
- Sharing a Device
- Setting up Device Sharing
- Shared Devices: Clocking Considerations
- Patching Shared Devices
- Patching Shared Output Devices
- Shared and Un-Shared Devices in the Patch
- Removing Shared Devices
- If the Sharing Host Becomes Unavailable
- Share Preamp Control
- Servers
- External Control Devices
- Setting Sample Rate
- Assigning I/O Devices Manually
- Working Offline
- Mixer Settings
- User Interface Settings Section
- Patch Window Sections
- The Patch Grid
- Mixer Layers
- Mixer Channels
- Mixer Layer Modes
- Using Plugins
- Monitor Panel
- INCORPORATING MIDI
- MACKIE CONTROL PROTOCOL
- Setting Up Mackie HUI in a DAW
- Setup Window Overview
- Part 4: Patch Window
- Part 5: Mixer Window
- Appendix
Appendix
SoundGrid Studio/ User Guide
117
Setting Up Mackie HUI in a DAW
The following are examples of how to set up a Mackie HUI in the most popular DAWs. If you cannot find the information you’re
looking for, refer to the user manual or website for your DAW.
Logic Pro X
1. Go to Logic Pro X menu > Control Surfaces > Set Up.
2. On the upper left side of the window, click
on “New” and choose “Install.”
3. Choose “Mackie Designs” – “HUI” and then click on “Scan.”
4. A pop-up window will appear. Click on
“Add Manually.”
5. In the HUI Device window, set “Output Port” and “Input Port” to “StudioRack.”