SoundGrid Studio User Guide / Owners Manual
Table Of Contents
- Welcome to SoundGrid Studio
- Part 1: Getting Started
- Part 2: Top Bar
- Part 3: Setup Window
- Setup Window Overview
- Network Controls
- Device Racks: Assigning and Managing Network Devices
- I/O Devices Racks
- I/O Device Racks Displays and Controls
- I/O Devices Menu Items
- SG Connect
- I/O Sharing
- Connected Systems
- System Inventory in Super Systems
- Sharing a Device
- Setting up Device Sharing
- Shared Devices: Clocking Considerations
- Patching Shared Devices
- Patching Shared Output Devices
- Shared and Un-Shared Devices in the Patch
- Removing Shared Devices
- If the Sharing Host Becomes Unavailable
- Share Preamp Control
- Servers
- External Control Devices
- Setting Sample Rate
- Assigning I/O Devices Manually
- Working Offline
- Mixer Settings
- User Interface Settings Section
- Patch Window Sections
- The Patch Grid
- Mixer Layers
- Mixer Channels
- Mixer Layer Modes
- Using Plugins
- Monitor Panel
- INCORPORATING MIDI
- MACKIE CONTROL PROTOCOL
- Setting Up Mackie HUI in a DAW
- Setup Window Overview
- Part 4: Patch Window
- Part 5: Mixer Window
- Appendix
Appendix
SoundGrid Studio/ User Guide
116
Faders: Follow Aux-Sends Flip
In the “Sends on Faders” mixer mode, the channel faders control the level of the aux send, not the channel itself. Select
“Follow Aux-Sends Flip” to enable controller faders to follow this behavior.
Master 1
Use this drop-down window to assign which channel the master fader is controlling. This can be the Main L/R mix or
any other channel or buss in the mixer.
Master 1: Follow Aux-Master Flip
When in the “Sends on Faders” mode, the master fader controls the aux channel. This setting determines if the
control surface master fader exhibits this behavior.