SoundGrid Studio User Guide / Owners Manual
Table Of Contents
- Welcome to SoundGrid Studio
- Part 1: Getting Started
- Part 2: Top Bar
- Part 3: Setup Window
- Setup Window Overview
- Network Controls
- Device Racks: Assigning and Managing Network Devices
- I/O Devices Racks
- I/O Device Racks Displays and Controls
- I/O Devices Menu Items
- SG Connect
- I/O Sharing
- Connected Systems
- System Inventory in Super Systems
- Sharing a Device
- Setting up Device Sharing
- Shared Devices: Clocking Considerations
- Patching Shared Devices
- Patching Shared Output Devices
- Shared and Un-Shared Devices in the Patch
- Removing Shared Devices
- If the Sharing Host Becomes Unavailable
- Share Preamp Control
- Servers
- External Control Devices
- Setting Sample Rate
- Assigning I/O Devices Manually
- Working Offline
- Mixer Settings
- User Interface Settings Section
- Patch Window Sections
- The Patch Grid
- Mixer Layers
- Mixer Channels
- Mixer Layer Modes
- Using Plugins
- Monitor Panel
- INCORPORATING MIDI
- MACKIE CONTROL PROTOCOL
- Setting Up Mackie HUI in a DAW
- Setup Window Overview
- Part 4: Patch Window
- Part 5: Mixer Window
- Appendix
Part 5: Mixer Window
SoundGrid Studio/ User Guide
86
To populate channels in the eMotion ST StudioRack layer, set
the StudioRack input channel to match the driver input channel
in the DAW track where the StudioRack is inserted.
This StudioRack instance will appear as a channel strip in the
StudioRack layer of the mixer. The channel input will match
the Input assignment in the StudioRack plugin.
By setting the StudioRack input to the same source, switching
from Input to Playback will match.
The name of the DAW track is displayed at the bottom of the
StudioRack instance and on the mixer StudioRack layer
channel strip.
Switch between Playback, Input or Auto in the mixer or on the StudioRack plugin. When a StudioRack is in
Playback mode, it and all members of the group are muted, since StudioRack is not used during playback.
You can assign a StudioRack to the switching group either on the StudioRack plugin instance or on the mixer.
Switch any member of the group to Playback, Input or Auto, and all other members of the group will switch.
If the StudioRacks layer button is active but some StudioRacks do not appear in the mixer, it probably means that those
StudioRacks are not assigned to I/Os.