SoundGrid Studio User Guide / Owners Manual
Table Of Contents
- Welcome to SoundGrid Studio
- Part 1: Getting Started
- Part 2: Top Bar
- Part 3: Setup Window
- Setup Window Overview
- Network Controls
- Device Racks: Assigning and Managing Network Devices
- I/O Devices Racks
- I/O Device Racks Displays and Controls
- I/O Devices Menu Items
- SG Connect
- I/O Sharing
- Connected Systems
- System Inventory in Super Systems
- Sharing a Device
- Setting up Device Sharing
- Shared Devices: Clocking Considerations
- Patching Shared Devices
- Patching Shared Output Devices
- Shared and Un-Shared Devices in the Patch
- Removing Shared Devices
- If the Sharing Host Becomes Unavailable
- Share Preamp Control
- Servers
- External Control Devices
- Setting Sample Rate
- Assigning I/O Devices Manually
- Working Offline
- Mixer Settings
- User Interface Settings Section
- Patch Window Sections
- The Patch Grid
- Mixer Layers
- Mixer Channels
- Mixer Layer Modes
- Using Plugins
- Monitor Panel
- INCORPORATING MIDI
- MACKIE CONTROL PROTOCOL
- Setting Up Mackie HUI in a DAW
- Setup Window Overview
- Part 4: Patch Window
- Part 5: Mixer Window
- Appendix
Part 5: Mixer Window
SoundGrid Studio/ User Guide
85
FOLLOW THESE STEPS TO CONNECT
a) Open the DAW session and set the Playback Engine to “Waves SoundGrid.”
b) Insert a StudioRack on each track where you want to perform low-latency monitoring while recording.
c) Confirm that the WSG logo is green, if not, click to access the SoundGrid Studio Setup window to address the problem.
d) Assign the StudioRack input I/O channel used for low-latency monitoring during recording.
e) Switch monitor signal between input and play. Monitoring can also switch automatically based on the host’s record/play
status. This is explained later in this section.
f) Group together several StudioRack instances so that they change status simultaneously.
Establishing a Link Between StudioRack and eMotion ST
Each channel in the StudioRack layer of eMotion ST is one StudioRack instance in the DAW, so there must be a way of
establishing a link between the two. There are two links that must be established: one between StudioRack and eMotion ST,
another between StudioRack and the input channel of the DAW.
Set StudioRack to the SG processing mode. This moves StudioRack processing to the SoundGrid
DSP server and establishes an initial connection between the mixer and the StudioRack. You can
simultaneously switch all instances in the host session to SoundGrid or Native. eMotion ST will not
recognize StudioRack channels that are set to Native CPU.