SoundGrid Studio User Guide / Owners Manual
Table Of Contents
- Welcome to SoundGrid Studio
- Part 1: Getting Started
- Part 2: Top Bar
- Part 3: Setup Window
- Setup Window Overview
- Network Controls
- Device Racks: Assigning and Managing Network Devices
- I/O Devices Racks
- I/O Device Racks Displays and Controls
- I/O Devices Menu Items
- SG Connect
- I/O Sharing
- Connected Systems
- System Inventory in Super Systems
- Sharing a Device
- Setting up Device Sharing
- Shared Devices: Clocking Considerations
- Patching Shared Devices
- Patching Shared Output Devices
- Shared and Un-Shared Devices in the Patch
- Removing Shared Devices
- If the Sharing Host Becomes Unavailable
- Share Preamp Control
- Servers
- External Control Devices
- Setting Sample Rate
- Assigning I/O Devices Manually
- Working Offline
- Mixer Settings
- User Interface Settings Section
- Patch Window Sections
- The Patch Grid
- Mixer Layers
- Mixer Channels
- Mixer Layer Modes
- Using Plugins
- Monitor Panel
- INCORPORATING MIDI
- MACKIE CONTROL PROTOCOL
- Setting Up Mackie HUI in a DAW
- Setup Window Overview
- Part 4: Patch Window
- Part 5: Mixer Window
- Appendix
Part 5: Mixer Window
SoundGrid Studio/ User Guide
75
LAYER SELECTOR
The Mixer Layer Selector panel at the bottom is used to choose which channels, groups, Auxes and Monitors, and link groups
are at the front of the display.
In this example, the Mixer layer type and the GRP/AUX layer are selected.
There are seven layers:
Channels Channels 1–16; 17–32; 33–48; 49–64
GRP/AUX Groups 1–8; Effects (aux) 1–8
Monitor Monitor (aux) 1–16
Link Link group controls 1–16
The number of active mixer layers is determined by the size of the mixer, which is set in the Setup window. Certain layers are
not available in smaller configurations, and a layer may not contain all 16 channels.