SoundGrid Studio User Guide / Owners Manual
Table Of Contents
- Welcome to SoundGrid Studio
- Part 1: Getting Started
- Part 2: Top Bar
- Part 3: Setup Window
- Setup Window Overview
- Network Controls
- Device Racks: Assigning and Managing Network Devices
- I/O Devices Racks
- I/O Device Racks Displays and Controls
- I/O Devices Menu Items
- SG Connect
- I/O Sharing
- Connected Systems
- System Inventory in Super Systems
- Sharing a Device
- Setting up Device Sharing
- Shared Devices: Clocking Considerations
- Patching Shared Devices
- Patching Shared Output Devices
- Shared and Un-Shared Devices in the Patch
- Removing Shared Devices
- If the Sharing Host Becomes Unavailable
- Share Preamp Control
- Servers
- External Control Devices
- Setting Sample Rate
- Assigning I/O Devices Manually
- Working Offline
- Mixer Settings
- User Interface Settings Section
- Patch Window Sections
- The Patch Grid
- Mixer Layers
- Mixer Channels
- Mixer Layer Modes
- Using Plugins
- Monitor Panel
- INCORPORATING MIDI
- MACKIE CONTROL PROTOCOL
- Setting Up Mackie HUI in a DAW
- Setup Window Overview
- Part 4: Patch Window
- Part 5: Mixer Window
- Appendix
Part 4: Patch Window
SoundGrid Studio/ User Guide
66
Mixer Channels, Mix Busses and Control Groups
M
ONO AND STEREO CHANNELS
• Input channels can be changed from mono to stereo by double-clicking on the M or L/R
buttons. When a mono channel is flipped to stereo, its name is shown in both the left
and the right sides.
• When a channel is flipped from stereo to mono, the left channel patch becomes the
mono patch.
• Mono/Stereo status reflects the current state of the channel and can be changed only on
Input channels.