SoundGrid Studio User Guide / Owners Manual
Table Of Contents
- Welcome to SoundGrid Studio
- Part 1: Getting Started
- Part 2: Top Bar
- Part 3: Setup Window
- Setup Window Overview
- Network Controls
- Device Racks: Assigning and Managing Network Devices
- I/O Devices Racks
- I/O Device Racks Displays and Controls
- I/O Devices Menu Items
- SG Connect
- I/O Sharing
- Connected Systems
- System Inventory in Super Systems
- Sharing a Device
- Setting up Device Sharing
- Shared Devices: Clocking Considerations
- Patching Shared Devices
- Patching Shared Output Devices
- Shared and Un-Shared Devices in the Patch
- Removing Shared Devices
- If the Sharing Host Becomes Unavailable
- Share Preamp Control
- Servers
- External Control Devices
- Setting Sample Rate
- Assigning I/O Devices Manually
- Working Offline
- Mixer Settings
- User Interface Settings Section
- Patch Window Sections
- The Patch Grid
- Mixer Layers
- Mixer Channels
- Mixer Layer Modes
- Using Plugins
- Monitor Panel
- INCORPORATING MIDI
- MACKIE CONTROL PROTOCOL
- Setting Up Mackie HUI in a DAW
- Setup Window Overview
- Part 4: Patch Window
- Part 5: Mixer Window
- Appendix
Part 3: Setup Window
SoundGrid Studio/ User Guide
59
User Interface Settings Section
The U/I Settings section is used to control meter behavior.
Input Meter
Sets whether the input meters on the eMotion ST mixer display pre-trim or post-
trim input values.
Mixer Window
Sets whether the Mixer window meters display channel/buss input or output signal.
Output Meter
When Mixer Window is set to Output Meters, this sets the meter view of
channels, groups, and auxes: pre-fader or post-fader.
Peak and Clip
Clip Threshold determines the level at which a peak light turns red, indicating clipping. Setting the Clip Threshold
below 0 dBFS provides a warning before clipping occurs. This setting does not affect the behavior of the peak level
indicator.
Clip Threshold: 0 to -28 dBFS, Clip Hold: 0–5 seconds, Peak Hold: 0–5 seconds
User-Assignable Keys
Frequent actions can be assigned to eight user-assignable keys.
Assignments are made from the drop-down menu associated with each key.
To recall a user key, select a number from among the buttons on the left side of the Assignment
panel.