SoundGrid Studio User Guide / Owners Manual
Table Of Contents
- Welcome to SoundGrid Studio
- Part 1: Getting Started
- Part 2: Top Bar
- Part 3: Setup Window
- Setup Window Overview
- Network Controls
- Device Racks: Assigning and Managing Network Devices
- I/O Devices Racks
- I/O Device Racks Displays and Controls
- I/O Devices Menu Items
- SG Connect
- I/O Sharing
- Connected Systems
- System Inventory in Super Systems
- Sharing a Device
- Setting up Device Sharing
- Shared Devices: Clocking Considerations
- Patching Shared Devices
- Patching Shared Output Devices
- Shared and Un-Shared Devices in the Patch
- Removing Shared Devices
- If the Sharing Host Becomes Unavailable
- Share Preamp Control
- Servers
- External Control Devices
- Setting Sample Rate
- Assigning I/O Devices Manually
- Working Offline
- Mixer Settings
- User Interface Settings Section
- Patch Window Sections
- The Patch Grid
- Mixer Layers
- Mixer Channels
- Mixer Layer Modes
- Using Plugins
- Monitor Panel
- INCORPORATING MIDI
- MACKIE CONTROL PROTOCOL
- Setting Up Mackie HUI in a DAW
- Setup Window Overview
- Part 4: Patch Window
- Part 5: Mixer Window
- Appendix
Part 3: Setup Window
SoundGrid Studio/ User Guide
44
If the shared device cannot synchronize to the new clock, it will be unavailable for sharing by that host.
Other hosts in the super system may be able to sync to the shared device if they can adjust their
clocks accordingly.
A shared device can be a slave or the clock master of in its own SOE network,
indicated by the M on the shared device’s icon (left). On the right, the device is
still the SOE master of the system it’s being shared with but is a slave within its
own system.
When devices from more than two systems are assigned to a system’s inventory, all systems must be locked to the
same master clock device.
Note: Changing the master clock assignment in a system that includes shared devices will result
in a clock reset in all associated systems. This results in a short audio dropout.