SoundGrid Studio User Guide / Owners Manual

Part 5: Mixer Window
SoundGrid Studio/ User Guide
108
Monitor Panel
The Monitor panel provides individual monitor mixes to four sets of headphones, as well as three custom control room mixes for
three different studio loudspeakers. Setting up a monitor consists of these steps:
Select a monitor mix (Headphones 1–4 or Control Room). The CR button to the left of
the Headphones title copies the sources and trims from the Control Room setup.
The selected mix is identified in the box at the top of the panel.
Use the central section to control the four mix sources for the selected mix:
A) Click on the text above the knob to choose source (devices, drivers, and mixer
channels).
B) Adjust the input level of each source.
C) Turn a source on or off with the ON button.
Insert up to four plugins for each mix. Adjust the relative levels of plugins with their
individual input/output controls.
Input level to Control Room.
Use the Output section to select output device channels for up to three different control
speakers (Control Room selection, left) or set the output device channel and set gain
for the selected headphone mix (right).
Control room monitors are managed here and include: gain, mute, mono, dim (with
adjustable dim level).
Talkback: click on the Gear button next to the Talk button to configure Talkback.
Use the Clear Solo icon to clear all solos in all layers. Choose between single solo or
latch solo mode. Clear also returns Aux on Faders to normal fader view.