SoundGrid Studio User Guide / Owners Manual
Table Of Contents
- Welcome to SoundGrid Studio
- Part 1: Getting Started
- Part 2: Top Bar
- Part 3: Setup Window
- Setup Window Overview
- Network Controls
- Device Racks: Assigning and Managing Network Devices
- I/O Devices Racks
- I/O Device Racks Displays and Controls
- I/O Devices Menu Items
- SG Connect
- I/O Sharing
- Connected Systems
- System Inventory in Super Systems
- Sharing a Device
- Setting up Device Sharing
- Shared Devices: Clocking Considerations
- Patching Shared Devices
- Patching Shared Output Devices
- Shared and Un-Shared Devices in the Patch
- Removing Shared Devices
- If the Sharing Host Becomes Unavailable
- Share Preamp Control
- Servers
- External Control Devices
- Setting Sample Rate
- Assigning I/O Devices Manually
- Working Offline
- Mixer Settings
- User Interface Settings Section
- Patch Window Sections
- The Patch Grid
- Mixer Layers
- Mixer Channels
- Mixer Layer Modes
- Using Plugins
- Monitor Panel
- INCORPORATING MIDI
- MACKIE CONTROL PROTOCOL
- Setting Up Mackie HUI in a DAW
- Setup Window Overview
- Part 4: Patch Window
- Part 5: Mixer Window
- Appendix
Part 5: Mixer Window
SoundGrid Studio/ User Guide
103
assignments. When a plugin is disabled, its name will remain visible above the slot and its icon will be grayed out. You can also
disable and enable a plugin by clicking its rack slot while holding down the Ctrl key.
Remove Plugin
Deletes the plugin from the rack slot. All settings and control assignments are lost. You can also remove a plugin by dragging it
off the mixer.
Copy
Copies the plugin and its settings. This enables pasting the plugin and its current settings to another rack slot. There are two
paste options: Paste [plugin name] and Paste [plugin name] Preset.
Paste [plugin name]
Pastes the copied plugin and its settings to an empty slot or replaces the plugin that occupies the slot. In certain
circumstances, it is possible to paste a preset into an existing plugin (see Paste [plugin name] Preset below).
Enable Sidechain
Enables or disables the plugin’s sidechain key input when an active sidechain is patched to an appropriate plugin. Sidechain
sources are established at the top of the Plugin Pane. Plugins with an active sidechain have a drop-down menu (S/C) that
patches the sidechain source.
Plugin Presets
Paste [plugin name] Preset
Pastes presets from a copied plugin to another plugin in the same family (e.g., Q10 to Q6, or L1 Ultramaximizer to L1 Limiter, etc.).
This does not replace the plugin, only the presets.
You cannot copy and paste presets between plugins that are not in the same family of plugins. You can, for example, paste a preset
from L3 Multimaximizer to L3LL Multimaximizer, but you can’t paste that L3 Multimaximizer preset to L1 Limiter or SSL G Channel. If
it’s not possible to paste a preset to a plugin, the Paste [plugin name] Preset menu item will not be available.